ECE R64 PDF
2 Heavy Concerns about ECE-R 64 with TPMS –The ECE R64 is about temporary use spare wheels / tires. It is not made to specify TPMS. –There are two. R Temporary use spare unit, run flat tyres, run flat system and tyre http:// ECE R Supplement 2 Temporary use spare wheels/tyres, run flat tyres, run flat system and tyre pressure monitoring system.
|Published (Last):||10 December 2004|
|PDF File Size:||1.84 Mb|
|ePub File Size:||14.88 Mb|
|Price:||Free* [*Free Regsitration Required]|
InterRegs: Regulation No. | ECE – United Nations
Date of test report: The vehicle eve be loaded to its maximum mass as defined in Paragraph 2. With the vehicle stationary and the ignition start switch in the “Lock” or “Off” position, turn the ignition start switch to the “On” “Run” position or, where applicable, the appropriate key position.
The tests shall be conducted in an environment free of interferences from radio wave. If applicable, name and address of the Manufacturer’s representative: If no owner’s manual is supplied with the vehicle, the information required in Paragraph 6. Production Definitely Discontinued Additional information about the significance of the low tyre pressure warning tell-tale illuminating and a description of the corrective action to be undertaken if this happens.
Our fast and easy means of purchasing up-to-date global vehicle and component standards and regulations on a pay-as-you-go basis. Supplement 1 to the 00 series of amendments Date of Entry into Force: If the system is blocked by external influence f64.
Specifications and Tests 6. Any tyre pressure monitoring system fitted on a vehicle shall comply with the requirements of Regulation No.
Provided that the motorist has a tyre sealant – such as IMS Instant Mobility System – on board, he may continue his journey in the majority of cases until there is an opportunity to have the tyre checked by a specialist.
In the case of N Category vehicles approved to Regulation No. Second-generation Warnair can be applied in vehicles of the categories M1 and N1 passenger cars and light commercial vehicles. Rim Position The vehicle rims may be positioned at any wheel position, consistent with any related instructions or limitations fce the vehicle’s manufacturer. r664
ECE regulations: ECE R Supplement 2
When tested to this procedure, the TPMS shall illuminate the warning signal described in Paragraph 5. Confirm the activation of the warning signal. Procedure for the diffusion test to verify the requirements of Paragraph 5. The normal frequency of these verifications shall be at least once per year.
The test shall be carried out with the temporary-use spare unit fitted alternately in place of one front wheel and one rear wheel. The warning signal shall be activated when the ignition start switch is in the “on” run position bulb eec.
Except in the case of a run-flat tyre, the tyres shall be inflated to the pressures recommended by the vehicle manufacturer for the vehicle type and loading condition. Confirmation or refusal of approval, specifying the alterations, shall be notified by the procedure specified in Paragraph 4. In the vast majority of r644 mobility will be maintained, therefore.
Frequently asked questions about DUNLOP TECH Warnair
Test Weight The vehicle may be tested at any condition of load, the distribution of the mass among the axles being that stated by the vehicle manufacturer without exceeding any of the maximum permissible mass for each axle. Subject to the requirements of Paragraph The tell-tale must illuminate and remain illuminated as long as the ignition locking system is in the “On” “Run” position.
The customer can enjoy a system that causes r644 further costs over the entire lifespan of his vehicle.
Test procedures for detecting a failure of the Run-Flat Warning System 2. However, in the case where there is no possibility to set or reset the system, the vehicle shall be unladen. Every modification of the vehicle type shall be notified to the Administrative Department which granted the type approval. The application for approval of a vehicle e64 with regard to its equipment with: The axle loads resulting from the loading condition in accordance with Paragraph 1.
The approval mark shall be clearly legible and be indelible. If you wish to have any further information, please use the contact data as displayed in the box on the right.
Trade name or mark of the vehicle: All text shall be enclosed in a border and be on a background of contrasting colour. Our online subscription service, offering immediate access ecee our extensive library of global vehicle regulations, standards and legislation.
The sum of the total cumulative drive time shall be the lesser of 60min of cumulative driving 6r4 the conditions set out in Paragraph 1. This is done by pressing a key on the dashboard or via the vehicle’s operation element HMIsuch as a touchscreen.
If the warning does not activate the test has failed. Why are tire pressure monitoring systems so valuable for motorists? No, there are not.