DRYPIX 4000 SERVICE MANUAL PDF
HANDLING THIS SERVICE MANUAL About This Service Manual n. Scope This Service Manual applies to the Fuji Medical Dry Laser Imager DRYPIX Service Technicians PACS / DR / CR / Digital Forum Drypix Service Manual CARLOS RUEDA Innovacion Tecnologica Hello, I am trying. View and Download FujiFilm DRYPIX service manual online. DRYPIX Printer pdf manual download.
|Published (Last):||13 September 2013|
|PDF File Size:||16.86 Mb|
|ePub File Size:||17.36 Mb|
|Price:||Free* [*Free Regsitration Required]|
MC Remove the sub-scanning unit fixing bracket. Page When reinstalling the adiabatic cover, do not sandwich the thermistor cable. Page Rail of equipment FP7C Press the LED cover of the density measurement light-emitting board against the position shown in the figure below, and manyal.
Page 88 35 x 43cm size 26 x 36 cm size 20 x 25 cm size EPS Change the attaching position of the film release plate.
FUJIFILM DRYPIX SERVICE MANUAL Pdf Download.
EPS Remove the upper conveyor unit removing jig. Operation Panel Remove the operation panel. The measured density steps should not exceed the range listed above. If problems are detected, corrective action must be taken before clinical films are processed under less than optimal conditions.
Removal Drive Cam Remove the gear 1 and gear 2. Prepare the PC for servicing. EPS Remove the sub-scanning unit fixing bracket, and reinstall it to its original position. Documents Flashcards Grammar checker. In addition, film aging and storage conditions can also affect the sensitometric characteristics of the film.
Page 28 Place the tip in front and behind the right rail of the tray loading unit on the aperture of the tray loading unit, tighten the rail temporarily with the screws. When completed, [File Copy Finish!!
Cleaning Roller Grip Release Motor md4 Rotate the worm gear of the cleaning amnual grip release motor MD4 in the arrow direction shown in the figure with the hand so that it grips the cleaning roller. Page 20 MC Remove the tray. Display in Community Feed.
Rotate the positioning screw in the clockwise or counterclockwise direction and adjust. Disconnect the network cable of the PC for servicing from the network to which the equipment is connected.
Inner slide rail FP7C When installation completed, the [Software Install Serviec Artifacts Banding, Scratch, Fog, etc. Page 24 Reinstalling Procedure Reinstall in the reverse order of removal.
Page MC Remove the film release unit. Shutdown the PC for servicing. Removing Procedure Insert the shutter into the film tray. Page 94 26 x 36 cm size 20 x 25 cm size Page 87 Remove the sub-scanning unit fixing bracket, and reinstall it to its original position.
Table of Contents Add to my manuals Add.
Page MC Remove the cooling fan assembly. Remove the cooling fan assembly.
Drypix 4000 service manual
Not only does each mammographic x-ray Film Positioning Motor upper md5 Remove the upper conveyor unit. When the data transfer is completed, the [File transfer is completed.
Got it, continue to print. Page 91 Rotate the positioning screw in the clockwise or counterclockwise direction and adjust. Bellows Remove the suction cup arm.
service manual – Fujifilm DryPix | MedWrench
Place the tip in front and behind the right rail of the tray loading unit on the aperture of the tray loading unit, tighten the rail temporarily with the screws. Turn ON the power of the equipment, and start the M-Utility. Geometry Output test pattern films and sservice the specified horizontal and vertical length to confirm it is within specifications.