ADC0804 DATASHEET PDF

0 Comments

The ADC ADC ADC ADC and. ADC are CMOS 8-bit successive approximation A D converters that use a differential potentiometric. Check for Samples: ADC, ADC, ADC, ADC, ADC products and disclaimers thereto appears at the end of this data sheet. ADC 8-Bit, Microprocessor-Compatible, A/D Converters. The ADCX family are CMOS 8-Bit, Details, datasheet, quote on part number: ADC

Author: Shaktilrajas Yokus
Country: Sierra Leone
Language: English (Spanish)
Genre: Art
Published (Last): 6 March 2007
Pages: 148
PDF File Size: 10.33 Mb
ePub File Size: 15.4 Mb
ISBN: 255-8-27591-436-5
Downloads: 80107
Price: Free* [*Free Regsitration Required]
Uploader: Vik

Goes high for interrupt request. Seven output Data bit pins from which output is obtained.

Activates ADC; Active low. As you can see in the image the voltage value is 1.

National Semiconductor – datasheet pdf

The chip select CS and Read R pin should also be grounded. Virgin Galactic — Commercial Space Flight. To set a particular voltage level as the reference value, this pin is connected to half the voltage. Analog inverting Input; normally ground. Only if this is done the ADC value on the output side will be update. ADC needs a clock to operate.

Related Posts  2002 FORD ESCAPE OWNERS MANUAL PDF

External clock can be connected here, else RC dayasheet be used for accessing ad0804 clock. An external clock can be given at the Clock IN pin. It is a pin Single channel 8-bit ADC module.

The step size can be adjusted by setting the reference voltage at pin9. Connect to ADC input. Analog Ground pin connected to ground of circuit. Input pin; sets the reference voltage for analog input.

Data bit 0 to bit 7. That is for every increase of RC timing resistor input pin for internal dac0804 gen.

National Semiconductor

Clock Input pin; to give external clock. Arduino based GPS receiver. When this pin is not connected, the default reference voltage is the operating voltage, i. ADC also has an inbuilt clock which can be used in absence of external clock.

ADC is a very commonly used 8-bit analog to digital convertor. Analog to digital converters find huge application as an adx0804 device to convert the signals from analog to digital form. The digital outputs vary from 0 to a maximum of Interface SD Card with Arduino. TL — Programmable Reference Voltage. The step size at 5V is Differential Analog input. Choosing Battery for Robots.

Related Posts  INTERVIEW WITH AN EXORCIST FORTEA PDF

Write pin should be pulsed high to start data conversion. Reference voltage for ADC conversion.

Used with Clock IN pin when internal clock source is used. It is a single channel IC, i. The time taken to convert the analog value to digital value adc004 dependent on this clock source. Output pin; Goes low when conversion is complete. These digital signals are used for further processing by the digital processors.